Nandpro 2.0e Release

[kim095 0]

http://www.megaupload.com/?d=9IMKR2VJ - Nandpro 2.0e

 

History:

 

2.0

nitial Release

 

2.0a

Fixed usage for +W, +w

Fixed problem with payload injection for large block nands

Fixed miscalc of file blocks togo when injecting !raw

No ARM code impact

 

 

2.0b

Remove "Press Any Key" for unattended batch file processing

Removed retry on individual sectors, retry entire block instead, including erase

attempt to program all sectors anyway, then report status

ARM code update required for above

Added ARM HW version test, (U32) 0000 0001 required or abort

Added "Virtual Nand" device

 

 

2.0c

Bit settling verify feature added for LPT reading

Add support for Jasper16a

Improved detection for virtual nand device, fixes some problems with writing to vnand.

Allways corrects the ECC bytes (but not SPARE), even in raw mode

ie: A raw file that has been hex edited can simply be flashed with -w

 

Added command line swithces:

%r will read SPARE data only, 16 bytes per block

@w will write RAW file, while correcting block numbers

Can "force" a flash config on command line by appending :HexFlashConfig

 

2.0d

For compatibility purposes -w does not calculate ECC

Raw files are flashed pure using -w. To correct ECC errors use *w instead

ie: A raw file that has been hex edited can simply be flashed with *w

 

2.0e

Fixed the "forced" flash config on command line for virtual nand device.

 

 

Note:

For the vnand: device the flash config is normally automatically detected.

Some "hybrid" 256/512 images can not be detected properly, to mount these files the config

value must be forced by specifying it as the last argument on the command line, preceeded by a ':'.

Only vnand: device may be forced!

 

Example:

nandpro vnand.bin: -r64 rawkv.bin 1 1 :AA3020

Изменено 18 марта 2010 пользователем kim095